[breadcrumb_simple]
Dell printers are known for their performance in terms of maximum yield and printing in number of copies. To correct Dell Printer Error 009-654 with a Dell printer, perform step-by-step instructions. The error code usually appears when the printer is suspended or unable to print. In most cases, the printer error is resolved by turning it off and turning it on for only 5 to 10 minutes, but if after that you are unable to resolve the Dell printer error.
If you are using a Dell laser printer and want to install, uninstall, or reinstall the printer, and have problems installing it. You can read this blog.
Causes of Dell Printer Error 009-654:
There can be several reasons that can lead your printer to display this error. Some of them are as follows:
- Sometimes when the transfer belt of your printer doesn’t sits well in your printer, it can lead to this error.
- This error is often caused by the usage of an old version of the firmware. And at times all your printer needs a reset.
- Well, by understanding the reasons, you can now handle the troubleshooting methods in a much better way and can take a better care of your printer for the future usage.
Steps to Fix Dell Printer Error Code 009-654:
Method 1: Disconnecting Power Cables
1.As a matter of first importance, you have to exclude the electrical link connected to the printer.
2.In addition, you can leave your printer for 2-3 minutes before that point when it stops and stops at it.
3.Reconnect all energy links and turn on the energy.
For a long time, start your printer and check that the case still works fine or not.
Method 2: Clear Head Contact Pin
1.Start your printer and clean the cart unit’s top contact stick.
2.Make sure you use the cartridge you are using for the printer.
3.After this, you have to test web link associations with the car.
4.Check, there is a chance that you are forgetting this.
5.For more successful methods, continue to the next step.
Method 3: Performance of Carriage Tasks
1.First of all, as a matter of importance, you have to kill your printer which was done by opening the board.
2.Now turn on the power and then let the print carriage grow on one side.
3.Because it goes far ahead, turn off the cover completely and switch to your printer.
